The company specializes in supplying Elisa kits, quality assurance, price concessions, and can provide free testing services, please call to consult!
This kit can only be used for scientific research, not for medical diagnosis.
Salmon Calcitonin (SCT) Quantitative Detection Kit (ELISA)
user's Guide
[Salmon calcitonin (SCT) ELISA kit name]
Salmon Calcitonin (SCT) Quantitative Detection Kit (ELISA)
[Salmon calcitonin (SCT) ELISA kit kit use]
Quantitative detection of serum, plasma and related fluids.
[Salmon calcitonin (SCT) ELISA kit detection principle]
This kit uses double-antibody two-step sandwich enzyme-linked immunosorbent assay (ELISA). Add the standard and the test sample to the pre-coated salmon calcitonin (SCT) monoclonal antibody transparent enzyme label coated plate. After incubating for a sufficient time, wash to remove unbound components, and then add the enzyme label working solution. After incubation for a sufficient time, washing to remove unbound components. Substrates A and B were added in sequence. The substrate (TMB) was converted into a blue product under the catalysis of horseradish peroxidase (HRP), which became yellow under the action of acid. The (SCT) concentration is positively correlated. The OD value is measured at a wavelength of 450 nm. Based on the OD value of the standard and the sample, the content of salmon calcitonin (SCT) in the sample is calculated.
[Composition of Salmon Calcitonin (SCT) ELISA Kit]
1
Enzyme coated plate
12 holes × 8
7
Developer A liquid
6mL
2
Standard
0.3mL × 6 tubes
8
Developer B liquid
6mL
3
20 times concentrated washing liquid
25mL
9
Stop solution
6mL
4
Sample diluent
6mL
10
Instructions
1 serving
5
Special diluent
6mL
11
Sealing film
2 sheets
6
Enzyme reagent
6mL
12
sealed bag
1
[Reagents and equipment not required by salmon calcitonin (SCT) ELISA kit]
1. 37 ℃ thermostat
2. Standard specification microplate reader
3. Precision pipettes and disposable tips
4. Distilled water
5. Disposable test tubes
6. Absorbent paper
[Operation steps of salmon calcitonin (SCT) ELISA kit]
1. Preparation: Remove the reagent kit from the refrigerator and re-equilibrate at room temperature for 30 minutes.
2. Mixing solution: dilute the 20-fold concentrated washing solution with distilled water to the original one.
3. Add standard products and samples to be tested: take a sufficient number of enzyme-coated plates and fix them to the frame. Set up standard wells, sample wells to be tested and blank control wells, record the positions of each well in the standard wells. Add 50μL of standard product; first add 10μL of sample to be tested, and then add 40μL of sample diluent (that is, the sample is diluted 5 times); blank control well is not added.
4. Incubation: Incubate in a 37 ° C water bath or thermostat for 30 minutes.
5. Wash the plate: discard the liquid, pat dry on the absorbent paper, fill each hole with the washing solution, let stand for 1min, shake off the washing solution, pat dry on the absorbent paper, repeat the washing 4 times (you can also use the washing machine to press Instructions for washing the board).
6. Add enzyme-labeled working solution: add 50μL of enzyme-labeled working solution to each well, without adding blank control wells.
7. Incubation: Incubate in a 37 ° C water bath or thermostat for 30 minutes.
8. Wash the plate: discard the liquid, pat dry on the absorbent paper, fill each hole with washing liquid, let stand for 1min, shake off the washing liquid, pat dry on the absorbent paper, repeat the plate washing 4 times (you can also use the washing machine to press Instructions for washing the board).
9. Color development: add 50μL of developer A solution to each well, and then add 50μL of developer B solution, mix for 30s with a plate mixer (or gently shake for 30s by hand), and avoid color development at 37 ℃ for 15min .
10. Termination: Remove the enzyme labeling plate and add 50μL of stop solution to each well to stop the reaction (the color changes from blue to yellow)
11. Determination: Zero the blank holes, and within 15 minutes after termination, measure the absorbance (OD value) of each well with a wavelength of 450 nm.
12. Calculation: According to the concentration of the standard product and the corresponding OD value, calculate the linear regression equation of the standard curve, and then calculate the corresponding sample concentration on the regression equation according to the OD value of the sample. You can also use various application software to Calculation. The final concentration is the actual measured concentration times the dilution factor.
[Sample requirements for salmon calcitonin (SCT) ELISA kit]
1. The sample cannot contain sodium azide (NaN3) because sodium azide (NaN3) is an inhibitor of horseradish peroxidase (HRP).
2. The specimen should be extracted as soon as possible after collection. The extraction should be carried out according to relevant literature. If the test cannot be performed immediately, the specimen can be stored at -20 ℃, but repeated freezing and thawing should be avoided.
3. The sample should be fully centrifuged, without hemolysis and particles.
[Notes for salmon calcitonin (SCT) ELISA kit]
1. The experiment is carried out in strict accordance with the instructions, and the result of the experiment must be determined by the reading of the microplate reader.
2. If the enzyme-labeled coated board is not used up after opening, it should be put into a sealed bag and added with desiccant immediately.
3. It is recommended that all standards, samples and blank controls be tested in duplicate, and the average value is taken to reduce the experimental error.
4. Keep in mind that the sample has been diluted 5 times. The calculation result is multiplied by 5 to obtain the actual concentration of the sample.
5. The quantitative range of this kit is 6.25-200ng / L. If it exceeds this range, it is calculated from the extension of the standard curve. It is not used for accurate quantitative results. ), Multiplied by the total dilution factor is the final concentration of the sample.
6. If the color is too light, the substrate incubation time can be extended properly.
7. In order to avoid cross-contamination, the tips, samples and blank controls should be replaced with a new one for each addition; the common components such as enzyme working solution, sample diluent and substrate should be cantilevered, and they should not touch the microwells. ; Do not reuse the sealing film.
8. The kits are used within the warranty period, and different batches of reagents should not be mixed.
9. Substrate B is sensitive to light and avoid prolonged exposure to light.
[Summary of operating procedures of salmon calcitonin (SCT) ELISA kit]
Prepare reagents, samples and standards
Add prepared samples and standards, and react at 37 ℃ for 30 minutes
Wash the plate 4 times, add the enzyme reagent, and react at 37 ℃ for 30 minutes
Wash the plate 4 times, add color developing solutions A and B, and develop at 37 ℃ for 15 minutes
Add stop solution
Read OD value within 15 minutes
Calculation
[Salmon calcitonin (SCT) ELISA kit detection range]
Please inquire
ã€Specification of Salmon Calcitonin (SCT) ELISA Kit】
96 servings / box 48 servings / box
ã€Storage of Salmon Calcitonin (SCT) ELISA Kit】
Store at 2-8 ℃, protected from light and moisture.
ã€Salmon Calcitonin (SCT) ELISA Kit Validity Period】
6 months
We are pleased for your visiting our Laminated Non Woven Bags !
We could offer you a simple service to order any types of Laminated Non Woven Bags using the convenience of internet technology. If you want to place large orders for Reusable Shopping Bag, submit the quote form, and look forward to exceptional prices. If you really want to show customers your store is green friendly, give the proceeds you get from sales of the Reusable Grocery Bags to an environmental organization. This will make people buy them more readily, and they will take care to use them, rather than plastic and Paper Bags .
Laminated Non Woven Bags, which is also Non-woven Bags , that is fully insulated with waterproof, reusable, durable and any other feature.
These laminated Reusable Shopping Bag based on the application can be divided into:
1. woven bags series: Non-woven bags, woven bags, Laminated Totes, laminated non woven bags, eco bags, non-woven bags, laminated totes bags.
2. non-woven bag series: non-woven paper bags, reusable shopping bags, packaging bags, non-woven bag,Promotional Bags.
3. series of non-woven products: non-woven storage box, storage box non-woven, non-woven suit sets - woven suit sets.
4. jewelry bag series: gift bags Drawstring Bags jewelry bags flannel bags, perfume, jewelry, bags pencil bags.
5. aprons series: advertising aprons, polyester aprons, cotton aprons, PVC aprons, aprons linked network.
We Having been in this Laminated Non Woven Bags profession for over a decade, it has now blossomed into a modern, comprehensive and competent enterprise specialized in creative design, copy, planning, printing, post production, etc. Its proficiency and competency have won it various honors like "First Class Printing Enterprises in WenZhou" and "Designated Government Procurement Supplier".
Certification Qualifications:
ISO9001 quality authentication
FSC certification
ISO14001 certificate of environment management system
Laminated Non Woven Bags
Laminated Non Woven Bags,Reusable Shopping Bag,Laminated Packing Bags,Non Woven Carrier Bag
WenZhou JinYuan Packing Manufacture Co.,Ltd , https://www.tote-shoppingbag.com