Three-dimensional business card production process (3)

2 Place the lenticular sheet on the business card printing paper to adjust the alignment. The lenticular sheet and the printing sheet should be aligned in the same direction. After the observed stereoscopic effect is satisfactory, the radiant sheet exposes the head of the adhesive layer and the head of the business card printing paper. Adhesive positioning. At this point, if the position of the lenticular sheet is found to be incorrect, some remedial adjustments may be made.

3 Put the lenticular sheets and printing papers that have been glued together on the headers into the inlet of the laminator. Lift the anti-fouling film on the reticle that has not been lifted off from the cutting line at the header. Be sure to pay attention to it. Go to the film on the diaphragm. To prevent the glue between the printing paper and the lenticular sheet before the rubber roller is pressed, separate the two by hand. Do not carelessness. Otherwise, bubbles or creases may appear on the page.