Barcode printer panel use point of attention

The general bar code printing device indicates the direction according to the figure, the dashed line is the ribbon mounting path, and the solid line is the label path. After recycling, the waste ribbon is not easy to peel off. Then, a smooth bottom paper with a waste label before use is wrapped around the reel, and then the ribbon is put on. When installing labels, adjust the paper limiter according to the width of the label. The indenter spring is even, which can avoid the deviation of the printer label. The paper is measured when using the printer for the first time.

Panel control
PAUSE button: Pause and start printing FEED button: Take a sheet of paper CANCEL button: When the print data is transmitted to the printer, but you do not need to print, press PAUSE first and then press CANCEL several times until the data light turns off.
CALIBRATE: Label test. When installing a new specification label, the label can be printed normally after testing the parameters of the label.
Method: Press the PAUSE key first, and then press CALIBRATE to perform the paper test (the label has an acceleration process during paper measurement, indicating correct paper measurement).
Note: The label for measuring paper can be rewinded and the ribbon cannot be rewinded.