Germany HYDRO-BIOS company-plastic water sample collector.pdf

Plastic water sample collector (water collector)-Plastic Water Sampler PWS

The plastic water sample collector PWS is composed of plastic (PVC) structure, and the sample inlet is very large.
Easy to rinse. The sampling cylinder is completely metal-free. The shutters at the end of the sampler are connected to each other by a strong rubber tube. After the hammer is dropped from the outside of the water surface along the cable, release the end closure to close the water collector.

When operating a single sampler on a cable, we recommend that you use an intermediate mounting bracket,
Keep the sampler vertical.

If you need to carry out a series of water collection work on a cable, you can install another hammer under each sampling cylinder. The release, thereby stimulating a series of sampling operations along the cable.

Ordering information of plastic water sample collector:
Plastic water sample collector (PWS) including hammer
436 300 Volume 1.7L
436 302 2.5L
436 305 Volume 5.0L
436 315 Volume 10.0L
436 325 Volume 30.0L

annex
436 335 three-channel thermometer tube
436 380 The middle mounting bracket of the plastic water sample collector and the smooth flow water sample collector,
Applicable volume 1.0-2.5L
436 385 The middle mounting bracket of the plastic water sample collector and the unobstructed water sample collector,
Applicable volume 5.0L
436 390 intermediate mounting bracket for plastic water sample collector and unobstructed water sample collector,
Applicable volume 10.0L
436 395 The middle mounting bracket of the plastic water sample collector and the smooth flow water sample collector,
Applicable volume 30.0L